Diamond Dust CW Kit Assembly Manual page 21

Section 1: Framing of the Airframe – Cont.
Step 22 – Cont.
The taper should be strait and consistent
towards the T.E.
Next, sand the cap strip over the #3 rib so it
flares around the L.E tube assembly. NOTE:
be careful to not sand through the Kevlar
thread that is wrapped around the L.E and
the #3 rib.
When sanding is complete, fill any gaps with
thick CA.
Step 23
Install a 1/16" x ½" cap strip to the top and
bottom of the #2 ribs using thick CA.
When you have both the top and bottom cap
strips installed on the #2 ribs, cut the cap
strip at the same angle, but a little longer
than the L.E tubes.
Then, sand and fill the gaps at the L.E. the
same way as shown for the #3 ribs in step
22.
21