Diamond Dust CW Kit Assembly Manual page 47

Section 6: Covering the Aircraft - Cont.
Step 5
Cover the other bottom half in the same
manner as shown in step 4. Make sure you
overlap the center section by at least ½".
Step 6
Turn the airframe over and install a piece of
covering that will cover the entire center
section, including the elevons all the way out
to the #2 ribs.
Step 7
In this step you may choose to cover the
remaining tip sections of the wings with a
different color. This will help with orientation
when the Diamond Dust is in the air. Make
sure you overlap the first layer of covering
over the #2 ribs.
Once you have all of the covering installed,
make sure to tack down the covering and
make a final pass along the leading edges
and over the center sheeting and motor
mount area.
47