Diamond Dust CW Kit Assembly Manual page 17

Section 1: Framing of the Airframe – Cont.
Step 17 – Cont.
Next, thread the Kevlar through one of the
small laser cut holes found on the motor
mount and wrap it around the leading edge
and motor mount 5 or 6 times while
reinserting it through the laser cut hole. Glue
it in with thin CA.
NOTE: you may have to re-drill the holes
since the laser cut hole may have been filled
in with glue from step 15
Repeat this for both sides of the motor
mount.
Step 18
Trim the .300 E glass tube flush with the
wing tip (Hack saw, razor saw,9+ or band
saw works well for this; a fine file will also do
the job).
After cutting off the extra tubing from both
L.E. tubes, sand the ends down flush to the
1/4"x1-1/2" elevon stock / balsa wing
tips.
17