Diamond Dust CW Kit Assembly Manual page 15

Section 1: Framing of the Airframe – Cont.
Step 15
Locate the triangle gussets from the parts
bag. The first ones are installed behind the
leading edge at the motor mount. Glue
them in with thick CA in the location shown
on the plans.
Note: the forward gusset should be
installed underneath the protruding tab from
the motor mount while the airframe is in the
upright position.
Next glue the triangle gussets, that are
positioned behind the L.E. and on the outside
of the #2 ribs, with thick CA.
NOTE: make sure you glue both the top
and bottom sides of gussets where they
connect to the leading edge and ribs.
Now add the motor mount doubler plate to
the bottom of the motor mount. Glue in using
thick CA all around the bottom of the motor
mount and clamp tight until the glue dries.
15