Diamond Dust CW Kit Assembly Manual page 32

Section 1: Framing of the Airframe – Cont.
Step 32 – cont.
Sand all the cap strips at the LE, and any
rough edges, being careful not to sand
through the Kevlar thread.
NOTE: you can also at this time, taper the
motor mount and doubler by sanding them
to a taper at the L.E of the motor mount.
Also, fill any holes or pockets around the
engine mount and LE with thick CA or
sawdust and CA.
32
Also, don't forget to seal any spaces found
around the cap strip and the motor mount/
firewall area.
Lightly sand all wood surfaces and wipe the
airframe clean. Set the airframe aside and
proceed to Section 2.