Diamond Dust CW Kit Assembly Manual page 39

Section 3: Vertical Fin Assembly – Cont.
Step 5 - cont.
Install the ¼" x 6" strip across the bottom of
the fins above the fin insert tab, again using
thick CA.
When you are finish applying all three carbon
strips, trim any excess carbon flush with the
fins. Note: Repeat step 5 for both sides on
both fins.
Step 6 – Optional Servo Hatch
Due to various servo sizes and servo choices
available, we have left it up to the end user to
decide whether or not to fabricate a servo
hatch cover for
compartment. A
necessary, you can cover the aircraft and
add a small piece of covering to cover the
servo area, but it does simplify things when
access is needed.
the servo/
servo hatch is not
We have included a few photos of the hatch
we have constructed using left over 1/16"
cap strip and cross grain sheeting.
radio
39