Fuel Tank Assembly - Diamond Dust CW Kit Assembly Manual

Section 4: Installing the Control Horns and Elevon Linkage – Cont.
Step 4
Screw the pushrods on to the ball links
on each elevon about halfway to start.
Reinstall your elevon servos and install the
control arms to the pushrods, making sure to
install the servo arms in the center of your
servos.
Note: You must power on your radio system
in order to properly center your servos at
their true center. Make sure your sub-trims
are zeroed out as well.
Step 5

Fuel Tank Assembly

Assemble the fuel tank stopper and brass
tubing as shown below. Care should be taken
to not kink the vent tube when bending. Also
make sure to leave approximately ¼" of play
between the clunk and the back wall of the
fuel tank.
43