Section 2: Elevon Construction - Diamond Dust CW Kit Assembly Manual

Section 2: Elevon Construction

Step 1
Locate the two precut balsa elevons
from the box. Please take note that the
elevon stock is NOT symmetrical.
Make sure to orient both elevons with the 90
deg. corners in the up position as shown
below.
Step 2
Next, locate a full length of ¼" x ¼" triangle
stock and cut two pieces slightly longer than
each elevon, making
approximately 1/8" extra on both ends of the
elevons for later sanding.
sure to leave
Step 2 – cont.
Glue the triangle stock, first using thick CA
and then applying thin CA
Note: you can trim the triangle stock easily
with a pair of scissors or hobby knife.
33