Diamond Dust CW Kit Assembly Manual page 11

Step 7
Place the engine mount in between the two
#1 ribs. You will first have to insert the front
part of the #1 ribs into the front part of the
mount in order to clear the leading edge
locking tabs.
Next, temporarily secure the mount into
position by using one #19 rubber band
around it and the #1 ribs
double the turns on the rubber band in order
to achieve a strong hold
You will have to
.
Step 8
Take the 1/16" x 1-3/4" x 4" balsa fuel tank
c
ompartment rear bulkhead
vertically against the front of the front spar
between the #1 ribs. Place a #19 rubber
band around the ribs to secure the bulkhead
as a spacer. You may have to double the
turns on the rubber band in order to achieve
a strong hold. Do not glue yet!!!
Next take the 1/8" x 3-7/8" x 1-3/4" plywood
switch plate and place it vertically on the
rear spar between the #1 ribs. Place a large
rubber band around the ribs to secure the
switch plate as a temporary spacer.
NOTE: Do not glue this plate to the ribs
or rear spar !!!
and lay it
11