Diamond Dust CW Kit Assembly Manual page 19

Section 1: Framing of the Airframe – Cont.
Step 20
Apply cap strips to both top and bottom of the
#3 ribs on both sides of the airframe.
Trim the cap strip with a hobby knife or
scissors to match the angle of the L.E. tube.
Step 21
Next, locate the leading edge hardwood
coving stock and apply one piece to each of
leading edge tubes with thick CA. Start at
the motor mount and apply rearward. Make
sure to leave a little at the motor mount so
you can cut and sand to shape later.
Note: Take care to apply the coving as strait
as you can on the L.E. tubes.
19