Diamond Dust CW Kit Assembly Manual page 52

Section 8: Final Equipment Installation – Cont.
Step 3
After you have established proper servo
movement and centering, Install your elevon
servos in the servo/ radio compartment and
attach the control linkage to the elevons.
NOTE: Complete steps 4 through 7 only if
you have a receiver that has a long wire
antenna. If you are using a spread spectrum
receiver, then install your receiver as per the
manufacturers instructions and then please
proceed to Step 8.
Step 4
Locate the small yellow antenna pull tube
and cut a small slit halfway through the tube
about ½" back from one end. Leave enough
tubing attached so you can hinge the ½"
piece of tubing back
52
Step 5
Pull the short semi-cut section back to open
the tube so you can insert the end of the
antenna in the open end on the short side of
the cut.
Step 6
Insert the opposite end of antenna pull tube
into one side of the antenna tube and feed it
through until it comes out the other side
.