Diamond Dust CW Kit Assembly Manual page 48

Section 6: Covering the Aircraft - Cont.
Step 8
Look at the aircraft from a frontal view and
determine if both wingtips are even with
each other. If not keep this in mind while
tightening the covering so you can make any
minor corrections. If this aircraft does not
trim out the same at high and low speeds
then you probably have some difference in
wingtip incidence and this can still be
corrected by re-tightening the covering.
Tighten the covering lightly on each side
before tightening completely.
Step 9
Once the covering is tightened, cut the
covering over the radio and fuel tank
compartments. You might want to leave
some extra around the compartments so
you can roll the covering into the openings
with your iron.
48
Step 7
Cover both vertical fins with covering. Make
sure to not cover the bottom of the fin or the
fin insert tab. Make sure when you cover the
fins that they are on a flat surface to keep
them straight.
Next Carefully cut out the fin insert holes that
are located on the rear top sheeting of the
airframe.