Diamond Dust CW Kit Assembly Manual page 14

Section 1: Framing of the Airframe – Cont.
Step 13
Next you will be installing the leading edges
on the airframe. Find the two tubes labeled
"L.E. Tubes" and slide each one through the
double rubber bands attached to the forward
spar halves. Make sure the 45 degree cuts
are facing the motor mount.
Insert the L.E. tube into the angled motor
mount tabs and rest the tube on both the #2
and #3 ribs.
Note you may have to slide the rubber band
back in order to increase the tension
between the L.E. and the front spar.
14
Once you have both leading edges aligned
and sitting on both the #2 and #3 ribs, place
a drop of thick CA on both sides of the #2
and #3 ribs at the leading edge. The square
end of the L.E. tube will extend beyond the
wing tips. Leave this extra length for now.
Step 14
Next, Locate the
plywood firewall and center it between the
#1 ribs and the motor mount plate. Apply
on both sides, where the firewall
glue
intersects the #1 ribs and where it touches
the motor mount, with both thin and then
thick CA. Then, cut the rubber bands holding
the motor mount.
1/8" x ¾" x 3-7/8"