Diamond Dust CW Kit Assembly Manual page 12

Section 1: Framing of the Airframe – Cont.
Step 9
Center the forward spar with the alignment
hole in the #2 rib (centered top and bottom),
and insert one of the 1/8" x ¼" x ½"
plywood spar end / rib locking tabs through
the rib and into the spar. Put a few drops of
thin CA where it is connected. Repeat on
the opposite side.
12
Step 10
Take the trailing edge assembly from step 4
of this section and slide it through the four
#19 rubber bands that are on the rear spar.
Place the rubber bands so they are
alongside the #1 ribs and on both sides of
the #2 ribs, as shown below. Line up all
spars and ribs to match the print as
precisely as possible.
When in place, put a drop of thin CA at
each rib to tack in place.
Note: the trailing edge of the ribs should
self center in between the 1/16" cap strips
on the T.E assembly.