Diamond Dust CW Kit Assembly Manual page 22

Section 1: Framing of the Airframe – Cont.
Step 24
NOTE: when installing the hardwood rails,
pay close attention to the direction of the
grain by looking at the end of the rails before
inserting them into the ribs. The grain should
go fore and aft and NOT up and down.
At this point, install your servo rails.
Take the
¼" x ¼" x 4-3/8" hardwood
and slide them through the
servo rails
square holes. Check to make sure your
servos fit. If your servos do not fit, make an
adjustment on the rear hole at this point.
The output shafts of the servos should be
completely above the ribs and sheeting.
22
Glue the servo rails in first using a drop of
thin CA between each servo rail and each #1
rib. Note: Center the rails so you leave
approximately ¼" sticking out on the outside
of both ribs.
When you have finished applying the thin
CA, apply a bead of thick CA around the
rails on both sides of each rib.