Section 1: Framing of the Airframe – Cont.
Step 32 – cont.
Next apply 1/16" cap strips to both #1 ribs
between the switch plate and firewall.
Apply two more cap strip pieces to the #1
ribs in front of the firewall leading up to the
front of the motor mount.
Cut the scrap 1/16" x 4-5/8" to fit the throttle
servo and fuel tank area.
Add another piece of 1/16" cap strip to the
partial rib in the fuel tank compartment.
Remember to apply all cap strips with thick
CA.
Make sure to check that you have clearance
for the throttle servo arm.
Turn the airframe over and apply the 1/16"
cap strips to the front of the #1 ribs at the
motor mount plate.
31