Section 8: Final Equipment Installation - Diamond Dust CW Kit Assembly Manual

Section 8: Final Equipment Installation

Step 1
Make sure your radio equipment is operating
correctly and your servo arms are centered.
Also be sure to zero out your trims and servo
trims on your transmitter BEFORE installing
your servo arms at center! This also includes
checking servos for proper direction before
attempting to cover the air frame
mentioned earlier.
Note: You may need to alter your radios
mixing in order to achieve proper orientation.
Some radios offer a delta wing configuration
Tip: Because of the amount of force placed
on the Diamond Dust's control surfaces,
plastic geared servos can fail prematurely.
Therefore we strongly suggest the use of
metal geared servos like the JR DS9411,
DS8611A or Hitec HS-5625MG.
Ensure you have proper servo direction
before you install servos.
as
Step 2
Both servos pull forward
Right Servo pulls forward
Left servo pushes back
51