Section 1: Framing of the Airframe – Cont.
Step 29
Locate the 1/8" x 3-7/8" x 1-3/4" plywood
switch plate and apply thick CA to the sides
and front part of the switch plate.
Refer to plans for proper orientation and glue
the switch plate so it is even with the side of
the ribs.
Step 30
Locate the two ¼" x ¼" x 7/8"
hardwood throttle servo rails. Pre-mount the
throttle servo to the short servo rails (this will
be used to set the spacing between the #1 rib
and the partial rib).
Next, determine which side of the fuel tank
compartment your throttle servo will need to
be positioned by which side of your motor the
carburetor linkage is located.
Place a drop of thick CA on each end of the
hardwood servo mount rails and install the
throttle servo as far forward as possible.
There should be enough room for the servo
arm to clear the top of the ribs and future cap
strips.
27