Diamond Dust CW Kit Assembly Manual page 13

Section 1: Framing of the Airframe – Cont.
Step 11
Square up and center the #3 rib on the T.E
and the rear spar extender. Next, insert the
wood tab through the #3 rib into the rear
spar extender. When everything is aligned
and square, first glue with thin CA and then
with thick CA. Repeat this step for the
opposite side.
Make sure that everything lines up on the
print and finish gluing all ribs to the trailing
edge.
Step 12
NOTE: be careful not to glue the
temporary spacers at the spars or the
rubber bands.
Make sure the fuel tank compartment rear
bulkhead is square and then first glue with
thin CA then with thick CA.
Next, glue the main ribs to both the forward
and rear spars first using thin CA, then fill in
around the spars with thick CA.
You can now cut the four rubber bands that
hold the T.E. assembly. Keep the remaining
rubber bands on the airframe, since you will
need these to install the leading edges of the
aircraft.
13