Section 4: Installing The Control Horns And Elevon Linkage - Diamond Dust CW Kit Assembly Manual

Section 4: Installing the Control Horns and Elevon Linkage

Step 1
Locate the two control horns along with
(8) 4-40 x 1" cap screws from the parts bag.
Before drilling the holes to mount the control
horns, make sure you have properly
positioned the control horn so the base of the
control horn is flush with the seam, where the
triangle stock and elevon stock are joined on
top of the control horn pad.
40
Once properly aligned, mark and drill four
holes in the elevons using a 1/8" drill bit.
Install the 4-40 x 1" cap screws and
LIGHTLY TIGHTEN AS TO NOT CRUSH
THE ELEVONS!!
Step 2
Next, you will have to determine which hole
on the control horn you will be installing the
ball link. If you are using high torque servos,
we recommend that you use longer servo
arms. No matter what length servo arms you
decide to use with your servos, you should
use a ratio of 1:1.