Table of Contents
Advertisement
ENGLISH
13. Wheel lock
13.1 Wheel lock installation
The wheel size will determine the
location of the mid-wheels lock.
The installation of the wheel lock
must be made when the rear wheels
are installed. Refer to section 7.1 to
install the mid-wheels.
1.
Determine the wheel lock
location according to the
adjustment hole;
2.
Using a 13 mm Allen key secure
tightly the wheel lock with bolts
and nuts A.
13.2 Adjust the tension applied to the wheel by the wheel lock
1.
Loosen bolt B using a 4 mm Allen key;
2.
As needed, move the wheel lock assembly forward or backward;
Tighten bolt B;
3.
4.
Verify if the desired tension is obtained and ensure the wheel locks
properly and securely;
5.
Firmly tighten.
Adjustment hole
13.3 To apply brakes
1.
Pull the handle C backward to apply the brake;
Push the handle C forward to release the brake.
2.
Figure 49: Adjustment and
Applying wheel lock
36
NEOX™ Tilt-in-Space
Figure 48: Wheel Lock
Advertisement
Table of Contents
