Owners manual
8. Back
8.1 Back angle modification
The NEOX™ back angle can be adjusted to satisfy
your client's needs.
To do so, follow these instructions:
1.
Unscrew screw A with a 10 mm and a 4 mm
Allen key.
2.
Once the screw has been removed, modify the
angle to meet your client's needs.
When the desired angle is reached put screw A
3.
in one of the preset holes.
4.
Tighten
Note: There is a 5º angle between every hole position.
Follow these instructions to replace a standard back by a dynamic back.
Changing back angle will affect stability. Please refer to Appendix A for table and
limitations.
21
ENGLISH
Figure 20 : Back Angle Modification
Revision 3
Janvier 2015