Table of Contents
Advertisement
ENGLISH
8.7 Installation - Angle adjustable pushhandle (optional)
To install the pushhandle please follow these instructions:
1. Remove the original coating (if applicable);
2. Insert the tube into the back tube receiver and screw bolt A using a 3 mm
Allen key;
3. Once adjusted and inserted, tighten locking screws B to lock tube C.
8.8 Angle adjustment of the pushhandle
1. Depress both push buttons A simultaneously. This will allow the handles to
rotate freely. Once the desired position is achieved, release push buttons A
and the handles will lock.
Figure 34 : Installation of the angle adjustable pushhandle
Figure 35: Angle adjustment of the pushhandle
28
NEOX™ Tilt-in-Space
Advertisement
Table of Contents
