Caster Installation - Physipro NEOX Tilt-in-Space Owner's Manual

ENGLISH

7.2 Caster installation

To change the Caster, simply follow these instructions:
Insert ball bearings G and bushing H inside the frame housing C if needed.
1.
Slide bolts F in fork E.
2.
Assemble fork components, bolts F and washer D in the frame housing C.
3.
Fasten the fork by tightening nut B using a socket and a ¾" wrench.
4.
5. Install cap A on the frame housing
Ensure tightness when the forks are installed. Verify that the fork rotates
properly. Otherwise, loosen nut slightly.
Any change to the Neox™ must be performed by a professional. Non-
compliance with this notice may result in severe consequences for the
safety of the users and individuals in contact with the base.
Figure 19: Caster Installation
20
NEOX™ Tilt-in-Space