Table of Contents
Advertisement
Take beam 3. Screw both frame connectors on the far-ends. Slide it
onto beam 2 and tighten it.
info@felixprinters.com
www.felixprinters.com
Take beam 2 again and screw the frame connector on it's far end. Then
slid it on beam 3 as indicated on the picture.
Next try to slide it also on beam 4.
Thighten the screws, again not too tight.
Now it is time for fine-tuning. Try to get every beam as level as
possible. Also align the beams as good as possible. See an example in
the picture below
Page 7 of 65
Advertisement
Table of Contents
