Table of Contents
Advertisement
Slide the big z-axis carrier part onto the smaller z-axis carrier part as
indicated in the picture above.
When put in place drill out the holes with a 4mm drill. Just a little
material should be removed in order to make a bolt go in there.
info@felixprinters.com
www.felixprinters.com
Mount the big part onto the z-axis carrier with small washers and m4x12
bolts. Tip: put the bolts in place with the supplied tweezers.
To further connect the two z-axis carrier parts, turn the frame upside
down.
Use 4x M4x16 bolts, on both sides use small washers. Put the washers
on the inside of the carrier into place with tweezers.
Page 12 of 65
Advertisement
Table of Contents
