Table of Contents
Advertisement
8
Module 5: Table (time: 1-2 hours)
Important notes:
Work carefully; this will benefit the print quality. Make sure that you don't warp the surface of the table by exerting too much force /weight on the table
BOM table
Part description
table_2mm
Resistor 4.7 Ohm - heated bed
Pre-crimped cables 2 threads
Piece of wire 2m
Silicone kit heat resistant
Cooling paste
4mm holes
Take the plate. Note that there are three, 4mm holes which are
reserved for the M4x30 countersunk bolts. Further more there are
eight 3mm holes which are reserved for the M3x8 countersunk bolts.
These are needed to mount the power resistors.
It is time to mount the M4x30 countersunk bolts. The order: bolt,
crinkled washer, large M4 washer, M4 nut.
info@felixprinters.com
www.felixprinters.com
Amount
1
4
1
1
1
1
The bed uses 4.7Ohm resistors. When all the resistors are drilled out
and they can be placed loosely on the M3 bolts. Put some cooling
paste on the flat side of the resistors; mount it as shown on the table.
Page 25 of 65
Advertisement
Table of Contents
