Table of Contents
Advertisement
11 Finishing touches (time: 30-45 min.)
1.
Check all the bolts if they are tightened correctly.
2.
Check if all the axes can move freely, without cables being jammed.
3.
Put a little bit of oil or grease on the z-spindle, to make it run smoothly. Preferably a thicker kind of grease or oil, we use motor-oil.
4.
When you have a printer with a shining through color, the opto-sensors of the axes might not work. To make them work you can put one
of the following things on the switching vanes:
a.
Non-shining through tape on the flange
b.
Tippex
c.
Piece of aluminum foil
5.
Mount the z-axis limit switch. Preferably put it 5 cm below the top edge of the z-axis rail. This way you prevent the hot-end from hitting the table
before the switching vane triggers the opto sensor.
6.
Mount the frame handle. Use the supplied M8 frame nuts and bolts to mount it. Place the frame holder as close to the vertical frame beam as
possible.
info@felixprinters.com
www.felixprinters.com
Page 40 of 65
Advertisement
Table of Contents
