Table of Contents
Advertisement
-
Fix the spindle with two M8 nuts. Turn the first nut by hand
against the bearing. Put a curved washer underneath the
nuts.
-
info@felixprinters.com
www.felixprinters.com
Screw the coupling on the spindle at the bottom end. Don't
forget to use a curved washer. Fix the coupling by holding it
and turning the m8 bolt against it. Don't fix it very tightly.
The curved washer is to compensate for an uneven surface
of the m8 nut. If you mount it too the curved washer will not
help anymore.
-
Put the printer upright and fix the m3 setscrew in the
coupling very gently on the motor-axis. You should still be
able to lift the coupling of the motor axis. Try to turn the
coupling with your hands gently and see if the motor is not
wobbling when rotating the coupling.
If it is wobbling try to fiddle the motor mount a little bit and
turn again. Repeat this until the motor is not wobbling
anymore. Now fix the setscrew of the the coupling.
You are now done with the z-axis.
Page 15 of 65
Advertisement
Table of Contents
