Table of Contents
Advertisement
10 Module 7: Electronics (time: 2-4 hrs.)
The goal of this module is to install all electric wires and to neatly put them away in the frame.
The required tools for this module are:
-
Soldering iron
-
Solder
-
Flux
-
Allen key
-
7mm wrench
To make the printer work properly the schematics below must be matched.
The description below will guide you step by step to match the schematics above.
NOTE: It is important that the cables are placed as neatly as possible. Placing the wires in a messy way, can lead to EMC problems, which than
can lead to unreliable printing. Also the board could become sensitive from outside influences, for instance when a lamp is switched on or off
the electronics could stop working until you reset it again.
After building several printers, we found that the best way to neatly do the cabling is to work from the electronics board to the components.
We use the following workflow:
info@felixprinters.com
www.felixprinters.com
Page 31 of 65
Advertisement
Table of Contents
