Table of Contents
Advertisement
Now it is time to glue the thermistor on the table and solder the wires.
Like displayed above
-
Start by soldering the wires onto the heat resistors:
- From the double wire cut 3 equal pieces of 200 mm. The rest of the
wire will go from the bed to the electronics.
because the rest of the wire goes from the table to the electronics.
- Strip all wire ends, twist the stripped end and guide it through the
holes of the resistors.
Steps for thermistor:
info@felixprinters.com
www.felixprinters.com
Don't waste too many,
- Glue the thermistor head approx. in the middle of the bed with heat
resistant silicone kit or other heat resistant type of glue.
- After glue-ing put some kapton tape on the wires to make sure the
thermistor stays in place.
- Let it dry.
Page 26 of 65
Advertisement
Table of Contents
