Table of Contents
Advertisement
Mount the motor to the x-axis motor bracket with the m3 countersunk
bolts. The bolts can be accessed through special holes and edges made.
Mount the x-axis rail with corresponding x-axis slider. (there is an "X"
drawn on the slider and rail). DON'T take the y-axis rail for this. Only three
mounting points are necessary to assemble the x-axis. Use the holes at the
far-ends of the rail and the middle one.
Fix the x-axis rail. The distance between the highlighted faces
should be approx 2mm.
info@felixprinters.com
www.felixprinters.com
Push the extruder onto the x-axis slider. This can go with some resistance.
But no need for drilling any hole out. Then fix it with m4x20 bolts and
medium washers.
Take the 2 printed x-axis belt mount parts.
Mount the bearing onto the two parts. From bottom to top:
M4x25 bolt, small washer, plastic part, large washer, small washer,
bearing,small washer, large washer, plastic part, small washer, self
prevailing nut.
Page 22 of 65
Advertisement
Table of Contents
