Table of Contents
Advertisement
1.
Mount the power supply to the frame
2.
Label all cables
3.
Place as much cables as possible to the electronics board.
4.
Connect the y-axis table wires to the board.
5.
Connect the opto sensors
6.
Connect the motor wires
7.
Connect the rest of the wires
8.
Clean it up and place the wires into the frame and cable spiral.
This section will walk through the above steps
10.1 Mount the powersupply.
BOM Electronics
Part description
powersupply_bracket_pt5
powersupply_bracket_pt4
ramps_case_pt1_v2
ramps_case_pt2_v2
ramps_support
RAMPS + arduino + steppers fully assembled
mini-ATX-seasonic
Power Cable NL,USA,Australian or British
Fan 40x40x10mm
heatsinks 10*8
precrimped cables 4 threads
precrimped cables 3 threads
USB cable 1.8m
heatshrinks large 50 cm
Heatshrinks small 15 cm
Get the parts described in the table above.
info@felixprinters.com
www.felixprinters.com
Amount
1
1
1
1
2
1
1
1
3
4
4
Place the plastic parts onto the powersupply with the powersupply
3
screws. The head on the screws may look different than on the picture,
1
but they have a phillips head and a courser non metric thread with a
1
4
length of 6mm and diameter of 3.3mm
Page 32 of 65
Advertisement
Table of Contents
