Table of Contents
Advertisement
Get the small aluminum beam, first put the plastic cap on it, next to the
drilled hole. This can be done with a hammer.
Slide in the small t-slot nut on the other side, and mount this beam
onto the middle hole of the y-axis rail with a M4x6 bolt.
Now it is time to connect the table assembly with the y-axis assembly.
- Take the table.Put it with the face on a flat scratch free surface.
- Put washers and curved rings on the m4x30 countersunk bolts. It is
important to match the amount of washers ond the picture above.
- On the 3 M4 countersunk bolts of the table make sure that on top of
the already placed rings from the previous module, there are 6 large
info@felixprinters.com
www.felixprinters.com
M4 washers and 5 curved rings in total. See the illustration above.
Now place the y-axis onto the table. When it doesn't directly fit, there is
no need to file any parts. The three bolts can be slightly re-oriented. This
can be done to exert a little sideway force on the bolt. When it still doesn't
fit, you could try to adjust the position of the small aluminum beam.
After placement mount table bolts with a normal M4 nut. Use a small
washer underneath the m4 nuts at the plastic parts. Use a large washer
for the bolt at the small aluminum beam.
Page 28 of 65
Advertisement
Table of Contents
