Table of Contents
Advertisement
Try to make the loops look nice by putting it in the cable spiral.
Finally manipulate the bundled cable to let it through the opening. The
cables must be pushed flat because the lid of the box must be placed on
there.
info@felixprinters.com
www.felixprinters.com
Get the heat sinks and put the self-adhesive conductive tape on it.
Place the heat sinks on the square chip on the stepper drivers.
Join the cables near the power supply in an as neat as possible way. You
could use cable-ties for that.
Page 38 of 65
Advertisement
Table of Contents
