Module 3: The Extruder (Time: 30-90 Min.) - FELIXrobotics Felix 1.0 Instruction Manual

6

Module 3: The Extruder (time: 30-90 min.)

Collect the following tools
- Allen key set
- Large file
BOM Extruder
Part description
Extru_base_v7
Extru_base_pt2_v4
Extru_base_pt3
Extru_arm_v2
Extru_belt_clamp_v3
Extru_airduct_v2
motor nema 17
Fan 40x40x10mm
small bearing
extruder_insert_piece
We will prepare all the parts before putting it all together. We start with the
extruder belt clamp/tensioner. Use m4x30 bolts and self-locking M4 nuts.
For the top bolt also use a small washer.
info@felixprinters.com www.felixprinters.com

Amount
1
1
1
1
1
1
1
2
2
1
Get the extruder arm. Mount an M4x20 bolt. From left to right:
M4x20 bolt, small washer, extruder arm, small washer, small bearing, self-
locking M4 nut.
Don't worry if the bolt doesn't go fully through the self-locking part of the
nut.
Get the extru_base_pt_3. And mount the bearing: From right to left the
parts are:
m4x20 bolt, medium washer, plastic part, small washer, bearing, self-
locking nut.
Again don't worry if the bolt doesn't go fully through the self-locking nut.
Page 16 of 65