Table of Contents
Advertisement
5.
The software is now configured for printing. Now it is time to configure the slicer. This is the part which slices a CAD file and
prepares it for printing. Go to Slicer and press setup.
Match all the fields in the picture below and afterwards press OK.
6.
Press the Configure button
The slicing settings must come up. Check under profile selection if there are several profiles present. If this is the case then the
configurations are set correctly. Close this window.
7.
Now back in the repetier main interface Activate the SFACT slicer. Now check if all the profiles are present.
info@felixprinters.com
www.felixprinters.com
Page 49 of 65
Advertisement
Table of Contents
