Table of Contents
Advertisement
Pre-assemble the z-axis limit switch vane. Use a ring and M4x16 bolt for
attachment to the frame. DO NOT mount it to the frame yet, because it is
a delicate part it should be mounted in the final stages of assembly,
otherwise the chances of damaging are very high.
Slide in a self-locking nut into side. Then mount an M4x16 bolt. Let the
tip of the bolt touch the flange as indicated in the picture.
Mount the pulley upside down onto the motor-axis. The distance from
the bottom of the pulley to the motor housing, should be approx. 2mm.
info@felixprinters.com
www.felixprinters.com
Place the rod with the coupling in place. See below for more instructions.
Do it in the following way:
-
Slide in the M8 nut into the side of the small z-axis carrier
part.
-
Guide the spindle through the z-axis spindle mount through
M8 nut just inserted in the z-axis carrier. Turn the spindle
until the bottom of the spindle has a distance of 2mm from
the top of the z-axis motor axis.
-
Page 14 of 65
Advertisement
Table of Contents
