Table of Contents
Advertisement
Now it is time to calibrate the z-height.:
-
Plug in the power cable. When doing the following steps, hold your hands on the usb connector. Plug it out if something goes wrong.
-
Make sure the fan in front of the hot-end and the fan in the electronics case is turning.
-
Make sure the bed is 1 cm from the hot-end.
-
Press Home X, then move the x axis back and forth. The axis will only move in positive direction if the Home X button is not pressed.
-
Press Home Y, move the y axis back and forth.
-
Press Home Z
-
The distance between the table and hot-end is probably too large.
-
Adjust the limit-switch vane and press Home Z again.
-
Do this a couple of times until the distance is less than the thickness of a piece of normal paper.
Scroll down the manual control window.
-
Check if the switchable fan mounted to the airduct is working.
Move the slider to 100%, (other values don't work) and press the fan button
You are almost ready to do your first print, please proceed to the next section.
info@felixprinters.com
www.felixprinters.com
Page 52 of 65
Advertisement
Table of Contents
