Table of Contents
Advertisement
Take beam 4 and 1. They must be connected as oriented in the above
picture.
Screw the frame connectors in the bottom of beam 4 as indicated in
the figure. Then slide beam 4 onto beam 1.
Slide beam 4 in position. On the side of beam 1 where the hex-key is
positioned there are two drilled holes. Tighten the frame connectors by
info@felixprinters.com
www.felixprinters.com
sticking the hex-key through the holes. Do not fix it too tight because
fine-tuning/leveling is needed later on.
Slide one of the two beams number 2 onto beam 1. Watch the
orientation of the drilled hole.
Turn the frame and fix beam 2 onto beam 1. Again not too tight.
Page 6 of 65
Advertisement
Table of Contents
