Connect The Motor Wires - FELIXrobotics Felix 1.0 Instruction Manual

The wires of the opto sensor should look like this on the z-axis carriage.
Like this on the opto switch of the x-axis.
info@felixprinters.com www.felixprinters.com


10.5 Connect the motor wires

Easiest is to start with the x-axis motor:
- From both ends remove excessive pieces of cable,
IMPORTANT: do not throw away the cut off pieces of cable because it has
to be used for later.
- Strip the ends, recommended to use a wire stripper.
- Join the ends together, but don't forget to put a piece of heat
shrink on each cable. Also make sure the colors match. NOTE:
Recommended to join the ends together as displayed above,
Page 36 of 65