Table of Contents
Advertisement
Put the parts together by using a m4x40 bolt shown in the picture. From
left to right the encircled parts are:
M4x40 bolt, medium washer, plastic part, medium washer, plastic part,
medium washer, plastic part, small washer, m4 self prevailing nut.
Watch orientation
Mount the hot-end. Move it from underneath the extruder base then slide
it onto the slotted hole. Finally fix the hot-end with the m8 nut. The
orientation of the top aluminum part is important, make it the same as the
picture.
info@felixprinters.com
www.felixprinters.com
2
1
Connect the 2 sub-assemblies to complete the hot-end. Use m4x20 bolts,
small washers and selfprevailing nuts.
Page 19 of 65
Advertisement
Table of Contents
