Table of Contents
Advertisement
Finally guide it through the belt-clamp.
is only one long belt in the kit, which must be divided in such a way
that it is usable for the x and y-axis.
When guiding the belt through the clamp, try to keep approx 2 cm
at one end. On the other end leave the remainder of the long belt.
Pull on both belt ends by hand to tension the belt, while keeping
the belt tensioned, thighten/close the clamp to fix the belt and keep
the tension.
info@felixprinters.com
www.felixprinters.com
Don't waste any belt. There
Increase the belt tension by turning the bolt and moving the clamp
away from the extruder base. When the belt is tightened normally
by hand, the distance between clamp and base should be about
2mm after tensioning. This needs further fine tuning later.
You have now finished the x-axis!
Page 24 of 65
Advertisement
Table of Contents
