Table of Contents
Advertisement
Put the provided double sided tape underneath the opto-sensors and
mount them onto the printed part. Mount them with the small bronze
screws.
NOTE: Don't screw it too tight, because that will deform the
opto-sensor.
Smoothen the surface a little bit on the inside, with a small file.
Put the big bearing inside the z-spindle holder. It should be a tight fit and
it can be pushed in.
info@felixprinters.com
www.felixprinters.com
Mount the z-axis motor.
IMPORTANT: the cables must be oriented
according to the picture.
Get the frame and put it on its side as shown in the picture.
Cross-section of aluminum beam
Insert the t-slot nuts as indicated in the previous picture. Tilt the t-slot
nut and push it in the frame approx. at the correct location. So, it is NOT
necessary to disassemble the frame, to insert a t-slot nut. Once it is in,
you can further position it with a small Allen-key.
Page 10 of 65
Advertisement
Table of Contents
