Table of Contents
Advertisement
File a flat side to the motor and mount the bronze piece onto the motor.
The distance of the motor_face to the bottom of the insert_piece should be
approx. 1mm. The top motor axle which comes above the bronze
insert_piece should ideally not be filed.
Mount the motor with insertpiece onto the extru_base_pt2 with 4 m3x8
countersunk bolts. IMPORTANT: the orientation of the motor should be
the same as on the picture.
info@felixprinters.com
www.felixprinters.com
Take the extru airduct and make the surface flat with a file. Careful,
because it's a delicate part.
Take the base part and level the surface as indicated on the picture. This
will ensure that the fan will lay flat when mounted on the surface.
Page 17 of 65
Advertisement
Table of Contents
