Table of Contents
Advertisement
20. ARPEG. B
Here you can make additional arpeggio-related settings. "LAST STEP" (knob 4 ) sets the number of steps in the arpeggio. "LATCH" (knob 1 )
specifies how the arpeggiator will operate when you release the keyboard, "SWING" (knob 2 ) adjusts the sense of swing, and "KEY SYNC"
(knob 3 ) specifies how the arpeggiator will be synchronized to the keyboard. In addition, "TARGET TIMBRE" (knob 5 ) specifies which
timbre(s) of a Layer synth program will be sounded by the arpeggiator.
LATCH
[OFF, ON]
SWING
Specifies how the arpeggiator will
Specifies the percentage (%) by
operate when you take your hand
which even-numbered notes of the
off of the keyboard.
arpeggio will be shifted in timing
relative to the first note.
OFF (
):
( Figure 20-1)
The arpeggiator will stop playing
when you take your hand off of the
keyboard.
ON (
):
The arpeggiator will continue play-
ing even if you take your hand off
of the keyboard.
Figure 20-1
When Resolution =1/8
Swing
— SYNTH/VOCODER
[-100...100]
KEY SYNC
Specifies whether the arpeggiator
will be synchronized to the key-
board.
If this is ON, the arpeggiator will
always start from the beginning of
the arpeggio pattern when you play
the keyboard. If you are perform-
ing together with other instru-
ments, you can use this function to
ensure that the arpeggio pattern is
aligned with the beginning of the
measure.
OFF (
Sync off (not synchronized).
ON (
Sync on (synchronized).
1
2
3
4
5
6
7
–50
–25
+25
[OFF, ON]
LAST STEP
Specifies the number of valid steps
(maximum number of steps) for the
step arpeggiator.
):
):
8
9
+50
[1...8]
TARGET TIMBRE
[Both, Timbre 1, Timbre 2]
Selects the timbre(s) that will be
sounded by the arpeggiator. This
can be set only for a Layer program.
Both (
):
Both timbres will be sounded by the
arpeggiator.
Timbre 1 (
):
Only timbre 1 will be sounded by
the arpeggiator.
Timbre 2 (
):
Only timbre 2 will be sounded by
the arpeggiator.
45
Hide quick links:
Advertisement
Table of Contents
