Korg Synthesizer/Vocoder micro Owner's Manual: Editing Each Timbre

Synthesizer/vocoder. Uploaded by: Da'Vidd Hollosy  
Hide thumbs

Editing each timbre

Synth programs can have up to two timbres.
A timbre consists of the parameters of EDIT SELECT 1 VOICE (except for
"SYNTH/VOCODER" and "SINGLE/LAYER") through LFO2 sections, and the
parameters of EDIT SELECT 2 PATCH 1–4 sections.
The VOICE section parameters "SYNTH/VOCODER" and "SINGLE/LAYER"
apply to the entire program.
Using both timbres (Layer)
Set the EDIT SELECT 1 knob to VOICE, and turn knob 2 to select
LAYER (
).
Selecting the timbre to edit
If you are editing a program that uses both timbres, here's how to select the timbre
to edit.
Press the EDIT SELECT TIMBRE SELECT key to select the timbre that you
want to edit. (The corresponding TIMBRE SELECT LED will light.)
Your editing will affect the selected timbre.
You can also edit both timbres simultaneously (Edit Sync).
1
Press and hold the TIMBRE SELECT key for at least two seconds.
Both TIMBRE SELECT LEDs will light, and editing will be synchronized for the
two timbres. The display will indicate the value for timbre 1. The value of
timbre 1 will also be used as the value at which editing begins.
2
To cancel edit sync, press the TIMBRE SELECT key.
Edit sync will be cancelled, and timbre 1 will be the object of
editing.
You can use the Solo function even while editing is
synchronized.
The state of the edit sync function is not saved.
14
Basic editing
Listening to only one timbre (Solo)
For a program that uses both timbres, you can use the Solo function to hear just one
timbre. This is convenient when you want to hear just one timbre while you edit.
1
Hold down the SHIFT key and press the TIMBRE SELECT key.
The TIMBRE SELECT LED for the timbre selected for editing will start blinking,
and only that timbre will sound.
If you want to hear only the other timbre, once again hold down the SHIFT key
2
and press the TIMBRE SELECT key.
The TIMBRE SELECT LED for the other timbre will start blinking, and only that
timbre will sound. The timbre selected for editing will also change at this time.
3
To cancel the Solo function, press the TIMBRE SELECT key.
The Solo state cannot be memorized.
Exchanging and copying the settings of the timbres
(SHIFT function)
You can exchange the settings of the two timbres, or copy the timbre settings from
another program. ( p.59)
SHIFT TIMBRE SELECT

Advertising

   Related Manuals for Korg Synthesizer/Vocoder microKORG

This manual also for:

Microkorg

Comments to this Manuals

Symbols: 0
Latest comments:
  • timothy a henry Dec 11, 2015 05:04:
    I couldn't get separate keys for my miro korg.

    I had to buy the whole key assemble

    ​I needed one ocatave of white keys

    timo​thy a henry
    ph# 647 785 5973

    than​ks