Korg Synthesizer/Vocoder micro Owner's Manual Page 29

Synthesizer/vocoder. Uploaded by: Da'Vidd Hollosy  
Hide thumbs
5. MIXER
These parameters adjust the volume balance of the oscillator 1 and 2, and the noise generator.
"OSC 1 LEVEL" (knob 1) sets the output level of oscillator 1, "OSC 2 LEVEL" (knob 2) sets the output level of oscillator 2, and "NOISE
LEVEL" (knob 3) sets the output level of the noise generator.
These settings will be the input level to the filter.
OSC 1 LEVEL
[0...127]
OSC 2 LEVEL
Sets the output level of oscillator 1.
Sets the output level of oscillator 2.
— SYNTH
[0...127]
NOISE LEVEL
[0...127]
Sets the output level of the noise
generator.
This noise generator generates
white noise. This is independent of
the white noise that can be selected
as a waveform for oscillator 1. This
does not have filter or resonance (as
the oscillator 1 noise generator, but
you can use the FILTER section to
create the same results as the noise
waveform of oscillator 1.
Noise is used to create percussion
instrument sounds, or sound effects
such as surf.
23

Advertising

   Related Manuals for Korg Synthesizer/Vocoder microKORG

This manual also for:

Microkorg

Comments to this Manuals

Symbols: 0
Latest comments:
  • timothy a henry Dec 11, 2015 05:04:
    I couldn't get separate keys for my miro korg.

    I had to buy the whole key assemble

    ​I needed one ocatave of white keys

    timo​thy a henry
    ph# 647 785 5973

    than​ks