Christie CP2220 User Manual page 159

Lens Vertical Position Adjustment (LVO)(Continued)
RNGP
Motor moving range in positive direction. Read-only.
RSET
Move motor to the center flag then move back to current position. Only valid parameter for this command
is 1. Set only command.
STRT
Start motor moving in specified direction, where direction can be (-1, 1). Write-only for v1.3 or newer.
STOP
Stops the motor. Write-only for v1.3 or newer.
MOVR
Moves the motor a given number of steps based on the current location. Write-only for v1.3 or newer.
EXAMPLES:
(LVO 500 1) Move lens to position 500 along vertical axis with positive approach
(LVO 500 -1) Move lens to position 500 along vertical axis with negative approach
(LVO+C101 -500 1) Set lens vertical position for channel 1 to -500 with positive approach
(LVO ?) Return current motor position along vertical axis and direction
(LVO+CALB 1) Calibrate the vertical axis
(LVO+RSET 1) Reset the vertical axis
(LVO+STRT 1) Starts motor moving in positive direction
(LVO+STOP) Stops motor
(LVO+MOVR -100) Move motor 100 steps in negative direction
(LVO+MOVR 200) Move motor 200 steps in positive direction
Monitor Card Cage Fans (MCF)
Enables or disables the monitoring of the two additional card cage fans. This command has no effect on a 2210 cin-
ema projector.
SUBCODE DESCRIPTION OF USE
NONE
Set to 1 to monitor and 0 to not monitor.
EXAMPLES:
(MCF 1) Start monitoring the card cage fans
Measured Color (MCG)
Select the Measured Color Gamut file. This file describes the native colorimetry for the cinema projector as
installed and is required for accurate color processing in the cinema electronics. This control is per channel to
allow for different colorimetry for applications such as 3D.
SUBCODE DESCRIPTION OF USE
Cxxx
Replace xxx with the channel number. Valid range is 101 - 164.
NONE
Select measured color gamut for the current channel.
CP2220 User Manual
020-100420-08 Rev.1 (5-2014)
Appendix B: Serial API
B-17