Install The Touch Panel Controller; Connect External Exhaust Ducting - Christie CP2220 User Manual

Section 2: Installation and Setup
To adjust the vertical or horizontal position of the cinema projector, extend or
retract the adjustable feet on the bottom of the cinema projector by rotating
them. When you finish the adjustment, tighten the lock nut.
2.7

Install the Touch Panel Controller

1. Loosen the mounting arm so that the end fits over the ball joint located on
the rear panel of the cinema projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector on the rear panel of the cinema projector.
4. Adjust the angle of the TPC.
2.8

Connect External Exhaust Ducting

Connect the ductwork that vents outside to the 8 inch diameter exhaust
port on the top of the cinema projector. Confirm that there are no
obstructions or bends in the ducting, all air intakes are free of
obstructions, and the vane switch at the exit duct moves freely.
The pre-installed outside-venting duct should be rigid at the cinema
projector and must also include a heat extractor and blower that
maintains a minimum of 450 CFM* when the cinema projector is
operating at less than or equal to 25°C ambient and less than 3,000
feet, while measured at the cinema projector exhaust opening.
WARNING
• *600 CFM is required in projection rooms with an ambient
temperature above 25°C or located at an elevation
greater than 3000 feet above sea level.
2-6
Exhaust
Duct to
Outside
450 cfm
required*
CP2220 User Manual
020-100420-08 Rev.1 (5-2014)